Threaded Mode | Linear Mode

James_902 · 07-18-2009, 08:06 PM

Thanks to eee-jay-ate I have hondata s300 on the way! Next thing is a wideband, more money Sad

**skunkdSiR** · 07-19-2009, 05:53 PM

I needa wideband Sad

boostedEJ8 · 08-05-2009, 07:50 PM

build the motor and run more boost Smile

James_902 · 08-13-2009, 03:25 PM

Update! s300 came in last week. Ordered a aem wideband o2 sensor 2 days ago. Also got the flange for my Pit BOV welded onto my intercooler piping. It's getting closer and closer Big Grin

:O!!!!!!!!!!!!!!

EsotericImage · 08-13-2009, 04:34 PM

wideband kit? or just sensor..?

Check glowshiftdirect, they have the whole kit for 200.00 with warranty
[Image: tintedWideBand.jpg]

AEM is too overpriced for me when u can get the job done with a different make. just my opinion tho.

James_902 · 09-02-2009, 09:27 PM

I bought a AEM wideband kit. Got it and the S300 in the car last week running it with the stock motor for now, it pulls a little harder with the basic street tune I have on it. I got the wideband to my door for $250 cdn. which I don't think is a bad price. Sandwich plate should be here tomorrow and I ordered a oil line and fittings last week but still haven't heard anything about it being shipped out yet :S

09-02-2009, 10:20 PM

i am really impress with this .,I am so glad I read this thread.,

________________
Furnace filter

stiffdogg06 · 09-03-2009, 06:13 AM

You can get an AEM wideband all over the place for $180-$200

Quote:with a bseries it wouldnt be that hard getting to 260hp, but with a D that would take a lot of money.
not a bad setup though, i think i have that same intercooler.

260whp don't have to cost a lot for a d-series.

Vitara pistons and hbeam rods. Done.

Hell, I made 240whp on my old y8 setup on a t3/t4 .50trim @ 11lbs.

James_902 · 09-04-2009, 04:12 PM

Sandwich plate came in today! I finally got an email about my oil line kit and it's on its way now. Also have a 2nd car now (03 corolla grocery getter FTW haha) so my car can be taken apart while I still drive.

James_902 · (This post was last modified: 09-25-2009 08:55 AM by James_902.)

Got the exedy stage 2 clutch in the car, also got the walbro fuel pump in. Switched up my valve cover and cleaned my tranny up a bit while it was out. Last but not least I have a ported LS intake manifold that was bead blasted so it looks better than new I blasted the IACV and throttle body to, cleaned up the engine bay pretty well.

here's a few pics
[Image: 003-4.jpg]