Short clip of my car being turned on after Seafoaming. The car runs a lot better than before now and my engine has well over 150K on it so i know it works good. I didn't rev it for too long because I didn't want to smoke up my whole neighborhood so I let it smoke for a while and then had some nice fun spirited Driving making sure not to go PAST THE SPEED LIMIT. hahaha. Anyhow, here's the initial start up and a little bit of smoking.

When I seafoamed my car I didn't get that much smoke at all.

Glad to hear it runs better. Where did you add the seafoam?

How did you do it Jeremy?

Mine smokes insane amounts no matter how frequently. It never fails. I always get so much.

i did that too my civic... and it smoked alllllot.. but again it ran alot better after.... i drove it around after i did it. white smoke blowing everywhere lol... i turned alot of heads :lol

I put half in the brake booster line and the rest into the gas tank. Let is sit for about 15-20 minutes and started her up. Very minimal smoke.

This post was last modified: 01-18-2008 11:18 AM by gimmezell.

I wonder....Your motor must be super clean for some reason.

Guys.....Please remember to change your oil IMMEDIATELY following the Sea Foam treatment. DO NOT rev to high when "burning it out" after adding it...and DO NOT drive car hard with this stuff in your oil. I don't even drive the car after treatment.

1. Treat it (Do the IM hose suck process last. Just when you're about to suck the last little bit up, completely submerge the hose....killing the motor.)
2. Let it sit for 10-15 min.
3. Start it and let it idle for 5-10 min.
4. Rev ever so slightly towards the end of the idle period to heat things up a bit and burn off the remaining smoke and carbon crap.
5. Change oil.
6. Change Plugs.
7. Do whatever other tune up stuff you need to do and call it a day.

oppps

thats a good bit of smoke, i did my before, it smoked for a good while, but it ran pretty nice afterwards

I should do this to my pathfinder