this is no a step by step im just gana tell you how to disable you srs light, wich in turn will get rid of the srs light but air bags will no longer work. I was going threw the honda manual to day and it says disconect the driver side and passenger side air bag then unplug you battery for 3min, hook the batt. back up and the srs will be disabled along with the light

This post was last modified: 01-06-2008 11:47 PM by turbo-2nr.

...or you can unplug the light from behind your gauge cluster and your airbags still work. Either way works I guess.

lol, nice, with all the stupid drivers around me i feel more comfortable with the airbags in working order (and maybe a helmet for commuter traffic driving)

or you can follow this step by step
i took it form dem0nk1d on honda tech
DIY SRS LIGHT BYPASS PLUG

Have you disable your airbag? Be it your driver side with an aftermarket steering wheel, or have just take your passenger bag out for what the reason. So now you have the damn SRS light stuck on? Well how do I fix the SRS system? Why shouldn't I just take the srs bulb out. By taking the SRS bulb out, your srs system still has a break in the system. So even if you have an airbag in which ever side that is still hooked up. The chances of it going off might not happen since you have a open circut in the SRS System. I am going to show you how to fix and, correct the issue by fooling the system.

----------------------------------------------------------------------------------------------------------------------------
TOOLS REQUIRED

1 Soldering Iron
1 Roll of solder
2.2 OHM RESISTOR **note make sure it's a plain 2.2 OHM RESISTOR. Not a 2.2K <-- Kilo Incorrect value
1 set of wire stripers
Small amount of Heat shrink tube
And cut connector from an old airbarg


----------------------------------------------------------------------------------------------------------------------------


Take and cut off the plug on your airbag or exploded air bag. This way it's a plug and play type connector.


Strip both sides of the SRS connector.
Solder in the 2.2OHM Resistor


Apply the heatshrink over the 2.2 OHM Resistor for protection.

Now plug in your newly made srs-bypass plug.

Now you'll have to reset the SRS System.

Under dash there should be a yellow plug. I usually take two long wires and use them to close and open the connection when needed....

1st step in erasing the memory is to turn the ignition off and connect the SCS Service connector to the MES Plug,

2nd Turn Ignition on. SRS indicator light will come on for about 6 seconds then go off.

3rd Disconnect SCS service connector for MES connector within 4 seconds after SRS indicator light goes off. SRS indicator light will come on again.

4th Reconnect SCS service connector the MES connector within 4 seconds after SRS light comes on. SRS indicator light will go off.

5th Disconnect SCS service connector from MES connector within 4 seconds. SRS indicator light will indicate that memory is erased by blinking 2 times.

6th Turn ignition off, and wait 10 seconds. Start vehicle like normal and light should come on and go out like normal. You have reset your SRS light. Done

...or you can unplug the light from behind your gauge cluster and your airbags still work. Either way works I guess.

i have a si cluster and i tried to just unplug the light but its not like the other lights its inside the cluster so you cant get to it unless you dissasimble the light
this way if dissableing it is for people that might have no air bags(aftermarket wheel and pass airbag eliminator tray) and want to get rid of the light easly

you could always go to a Honda dealer and get them to reset it if you dont have a after market steering wheel, or have taken out the passenger airbag... just saying.